Im not 100% sure for its the thing with Edid-editor or FX-config or even both but this was realy simple fixed! 8-channel's + codec-support (which already is supported by your monitor) with a EDID-Editor like CRU 1.5.1Īnd if i remember me right it strictly requires a clean setup with the "Microsoft Audio Home Theater Effects". In terms of PCM, if SPDIF was updated slightly along side the multichannel programming, HDMI would be almost redundant for audio only (optical is immune to many Bryan Ü: (equivalent to need to activate max. If SPDIF had the same level of multichannel output support as HDMI (which it can), it would be superior (and was before 2.0). HDMI 2.0 can process up to 8 x192khz (1,536khz), this is the same as my ALC analogue direct, 8 x 192khz, this is PCM processing, not bitstreaming. My AMD with 1.4, and ALC 889 SPDIF can process up to 6 x 192khz (1,152khz). Note: SPDIF is as good as HDMI 1.4, except it can do up to 125mbps in bitstreaming (HDMI is ~37mbps). I'm guessing everything else is working on HDMI? Windows can be stupid at times, and even break its self after a fresh install.Ĭould be drivers, I get problems with Windows and using EDID drivers, I dislike HDMI with video for audio only. Note : Feel free to remove any Realtek SFX, MFX, EFX points using FX config (if preferred).Įnjoy ALC Pro DTS:X Snk3, very odd, not sure what the problem is there, on my HDMI and AMD it works, as well as Realtek SPDIF, good to know you have it working on SPDIF. Some VPN's software may block the APO4 service, and need configuring.ĭTS settings can be used to setup another device, or set SPDIF to stereo mode.Ĭhanges: Fixed a delay and volume issue caused by DTS SFX (temporarily disabled, pending update). Workaround: Switch to speakers-headphones then back each startup (or use VB cable, other). Known issues: Some digital output devices are not detected properly with Ultra when in stereo output mode. See '\TOOLS\' for extra steps to unlock more features, settings, via the Realtek policy editor (RTK Device Tool.txt).Įnable 'Stereo Mix', mute the stream, then set it to play to the device, to keep the encoder always on. * Make sure you run CCleaner registry cleaner a few times, and remove any apps before restarting.
In 'device manager' again, in 'system devices' disable 'High Definition Audio', I have two and its the first one, restart*, install, enable. To install-update the drivers, right click uninstall the device in 'device manager', tick 'delete driver', pnputil to remove the extension ( see here). Features: DTS:X Ultra, DTS Headphones:X v2, DTS Interactive:X (APO4).
0 kommentar(er)
